Type 2 Door Installation

1. Mount the bottom bracket as shown below.  (The jamb guard is not designed to enclose any part of the hinge, but rather to protect the hinge from damage by forklifts or carts.)  *Measure from the top of the jamb guard or from the floor if no jamb guard is used.

2. Install the top bracket onto the top shaft pin on the door and set the door onto the bottom bracket by sliding the bottom shaft pin completely into the bottom bracket.

3. With the door in the closed position, slide the top bracket all the way down on the top shaft pin.  From that point, raise the top bracket up 5/16" and mount it at that location.

4. If the doors are not lined up with each other in the closed position, loosen the nuts on the adjusting plate on the bottom bracket and rotate the adjusting plate until the doors line up.

5. The door will have some play in it to allow for an axial tilt of approximately 4 degrees.

IF YOU HAVE ANY QUESTIONS, PLEASE CALL US AT 800-234-1069.

Back to Aluminum Traffic Doors Diagrams